Run to Cursor  
Top  Previous  Next


Toolbar   scriptruntocursor  
Menu:   Script > Run to Cursor  
Keyboard:   Ctrl+F10  
 
Use this command to run the script to the line where the cursor is located. When the execution reaches the current line, the script will stop and switch into the "Pause" mode, as will be indicated on the status bar of the Script Editor
.

You can run the script to the cursor from the beginning, or you can start it from a specified line by double-clicking on it and then applying the Run to Cursor command.

Note, that this command is only available when the script is in the "Idle" or "Pause" mode.